|

   

|

Features:
The solar street lighting
system provides automatically controlled street lighting, with each
luminaire illuminating an area of over 100 feet in diameter. The lamps
turn themselves on at dusk and off after 12 hours at dawn. The HID lamps
are brighter than halogens and have an average lifespan of 12,000 hours!
The system comes equipped
with:
-
3.5 m long structural
aluminum lamp extension and comes with the solar panel mount.
-
High efficiency 120 Wp
monocrystalline silicon photovoltaic panel.
-
Street lamps, which
includes a 35W high pressure sodium lamp, inverter and 11 W PLCE lamp.
-
Multifunction charge /
discharge controller.
-
12 V deep cycle
maintenance-free battery.
-
Battery enclosure.
-
Battery desulfator to
prevent sulfation and extend the battery lifespan
Advantages:
-
More cost-effective than
having to dig trenches, bury power cables and install substations for
conventional street lighting systems.
-
Immune to blackouts and
brownouts that may be experienced by the national grid network.
-
Does not require manual
switching of luminaries. The multifunction controller comes with 16
preset ON/OFF combinations.
-
Very low maintenance
(almost nil).
-
Each luminaire is
individually powered, meaning that a malfunction in one circuit would
not cause an entire section of a street to be cast in darkness.
-
Utilization of solar power
means that fossil fuel is not required to be provide power. This means
less carbon dioxide is released to the atmosphere, reducing the
severity of the greenhouse effect.
-
Low voltage (12 Vdc) is
safer for public use than conventional 240 Vac systems.
Sample Configuration Block
Diagram:

Solar Requirement:
A minimum of 1 kW/m2
of solar irradiance (approximately 5 hours of strong direct sunlight) is
required to obtain 8 hours of a 3,500 lumens bright light (colour
temperature of 4000oK) and 4 hours of 600 lumens light (colour
temperature 4500oK).
|
Luminaire |
Brightness |
|
DC E/SON 9 W (warm white) |
600 lumens |
|
Metal Halide 35 W (cool white) |
3,500 lumens |
Multifunction Charge /
Discharge Controller:
Specifications:
|
Nominal Voltage: |
12 VDC |
|
Solar In: |
10 A |
|
IOUT: |
10 A |
|
No of Outputs: |
2 |
|
Output ON/OFF Configurations: |
16 |
|
Built-In Protection: |
Battery Overcharge
Low Voltage Disconnect
Surge Protection
Polarity Protection |
Preset Timing Control:
|
Mode |
Hour |
|
|
1 |
2 |
3 |
4 |
5 |
6 |
7 |
8 |
9 |
10 |
11 |
12 |
|
0 |
|
|
|
|
|
|
|
|
|
|
|
|
|
1 |
|
|
|
|
|
|
|
|
|
|
|
|
|
2 |
|
|
|
|
|
|
|
|
|
|
|
|
|
3 |
|
|
|
|
|
|
|
|
|
|
|
|
|
4 |
|
|
|
|
|
|
|
|
|
|
|
|
|
5 |
|
|
|
|
|
|
|
|
|
|
|
|
|
6 |
|
|
|
|
|
|
|
|
|
|
|
|
|
7 |
|
|
|
|
|
|
|
|
|
|
|
|
|
8 |
|
|
|
|
|
|
|
|
|
|
|
|
|
9 |
|
|
|
|
|
|
|
|
|
|
|
|
|
A |
|
|
|
|
|
|
|
|
|
|
|
|
|
B |
|
|
|
|
|
|
|
|
|
|
|
|
|
C |
|
|
|
|
|
|
|
|
|
|
|
|
|
D |
|
|
|
|
|
|
|
|
|
|
|
|
|
E |
|
|
|
|
|
|
|
|
|
|
|
|
|
F |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Output 1 ON |
|
|
Output 2 ON |
|
|
|
|
|